How to extend your Wireless Network by building a 2.4 gHz wifi cantenna - How to extend your Wireless Network by building a 2.4 gHz wifi cantenna - P.2
| Networking - WiFi - Wireless |
Page 2 of 5
Here are the parts you will need for your wifi cantenna:
You will also need a piece of aluminum at least 4 inches in diameter (not shown).
Snap the dryer vent tube together, and make sure the edges are flush at the seam. Measure 13.5 inches from this end, and cut the tube to this length.
Solder aprox. 1 1/2 in. of 14 ga. wire to the N Connector. I connect a spare N male to dissipate heat from soldering.
Measure 1.75 inches from the edge of the vent.
Drill, then use a reamer to enlarge the hole so that the N connector will properly seat on the surface.
