How to extend your Wireless Network by building a 2.4 gHz wifi cantenna - How to extend your Wireless Network by building a 2.4 gHz wifi cantenna - P. 3
| Networking - WiFi - Wireless |
Page 3 of 5
Remove all of the burrs as a result of the reamer.
Drill 4 holes for mounting the N connector. I placed the heads of the screws in from the inside with washers.
Measure a piece of scrap wire 1.25 inches, and cut it to length. This wire is a measuring guide that is to be used in the next step to cut the actual antenna element.
Using this wire as a measuring guide, cut the wire that is soldered to the N connector to the 1.25 inch length.
